What to do if my MPPT Huber SCL-60A Controller shows an over charge current?
If your MPPT Controller indicates an over charge current, first restart the charger. If the problem persists, it is recommended to contact your installer for further assistance.
How to fix an over temperature issue with my MPPT Huber SCL-60A Controller?
To address an over temperature issue with your MPPT Controller, ensure the charger is in a cool environment. If the problem continues, contact your installer.
What to do if there is no display on my MPPT Huber SCL-60A's LCD screen?
If the LCD screen on your MPPT Controller is not displaying anything, check the battery wire connection. If the connection is secure, push the button. If the screen remains blank, contact your installer.
How to troubleshoot PV high loss on my MPPT Huber SCL-60A?
To troubleshoot PV high loss on your MPPT Controller, first check the voltage of the solar panel, ensuring it is less than 140V. If the voltage is within the correct range, contact your installer.
What should I do if my MPPT Huber SCL-60A Controller shows that the battery temperature is too high?
If your MPPT Controller indicates that the battery temperature is too high, check your remote temperature sensor and your battery ambient temperature. If the problem persists, contact your installer.
What should I do if my MPPT Controller shows that the battery temperature is too low?
If your MPPT Controller indicates that the battery temperature is too low, check your remote temperature sensor and your battery ambient temperature. If the problem persists, contact your installer.
General| Rated Charging Current | 60A |
|---|---|
| Max. PV input voltage | 150V |
| Maximum PV Input Voltage | 150V |
| Battery Voltage | 12V/24V/48V Auto |
| MPPT Tracking Efficiency | ≥99% |
| Communication | RS485 |
| Protection | Short Circuit, Over Temperature |
| Cooling | Fan |
Describes assembly, installation, operation, and troubleshooting of the unit.
Provides safety and installation guidelines, tools, and wiring information.
Contains essential safety and operating instructions for the unit and its proper use.
Highlights key functionalities such as MPPT technology, three-stage charging, and sensor compatibility.
Instructions for inspecting package contents, preparing the unit, and selecting an appropriate mounting location.
Covers the safe power-up sequence and describes the front panel's indicators, button, and LCD display.
Details the Bulk, Absorption, and Float charging stages for optimal battery performance and longevity.
Describes the necessary conditions, software, and communication setup for parallel charging multiple units.
A comprehensive table listing fault codes, their events, and recommended solutions for common issues.
Lists key electrical parameters including nominal voltage, current, power, and voltage ranges.
To Next Page
