TEMPO
®
/ TEMPO/PLUS
®
/ TEMPO/REMOTE
®
/ TEMPO/EXT
®
• Owner’s Manual
8
TEMPO
®
/ TEMPO/PLUS
®
/ TEMPO/REMOTE
®
/ TEMPO/EXT
®
• Owner’s Manual 9
TEMPO
®
Operating Instruction
Setting the temperature
The control is preset and will display the tempera-
ture setting of 110°F (default setting). Use the UP
and DOWN keys to change the temperature seting
from 105°F to 120°F in one degree increments.
Set the steambathing temperature according to
personal preference, however it is highly recom-
mended to begin steambathing at a low temper-
ature setting to gauge comfort and safety levels.
Changing the Temperature Units (°F/°C)
Hold ON/OFF key for 10 seconds. The temper-
ature units will be displayed as Fahrenheit (TuF)
or Celsius (TuC). Use the UP/DOWN keys
to choose between (TuF) and (TuC). Press
PAUSE key to accept the new value and exit.
Timer feature
When the control is turned ON a 60 minute
time duration is initiated. The control will turn
off after 60 minutes unless the control is turned
off manually.
Memory feature
If the control is turned off manually before 60
minutes then the default temperature of 110°F
will be used the next time the control is turned
on. If the control times out at 60 minutes (not
manually turned off) then the previous user
temperature setting will be used when the
steambath is used again.
The TEMPO
®
Control features programmable digital temperature
control, a xed (60) minute duration, ON/OFF and PAUSE.
ON/OFF
Press the ON/OFF key to start or stop the ow
of steam.
Steam will begin to ow a few minutes after
the control is turned ON. The duration requi-
red for the steamroom to reach steambathing
temperatures depends on the steamroom
construction and steam generator specica-
tions. Steam may continue to ow for a short
time after the control is turned OFF.
PAUSE feature
If a pause in steam ow is desired press the
PAUSE key. The display will ash while the
control is in the PAUSE mode. The timer will
continue to countdown while in the PAUSE
mode.
To Next Page
Loading...
Need help?
General