TEMPO
®
/ TEMPO/PLUS
®
/ TEMPO/REMOTE
®
/ TEMPO/EXT
®
• Owner’s Manual
10
TEMPO
®
/ TEMPO/PLUS
®
/ TEMPO/REMOTE
®
/ TEMPO/EXT
®
• Owner’s Manual 11
Setting the temperature
Press TEMP key to set the desired temperature
or display the temperature setting.
The control is preset and will display a tem-
perature setting of 110°F (default setting).
With the temperature displayed, press the UP
or DOWN keys to set the desired temperature
(105°F to 120°F) in one degree increments.
Set the steambathing temperature according
to personal preference, however it is highly
recommended to begin steambathing at a
low temperature setting to gauge comfort and
safety levels.
Changing the Temperature Units (°F/°C)
Hold ON/OFF key for 10 seconds. The temper-
ature units will be displayed as Fahrenheit (TuF)
or Celsius (TuC). Use the UP/DOWN keys to
choose between (TuF) and (TuC). Press PAUSE
key to accept the new value and exit.
Memory feature
If the control is turned off manually before it
times out then the default settings of 20 minu-
tes and 110°F will be used the next time the
control is turned on. If the control times out
(not manually turned off) then the previous
user time and temperature settings will be used
when the steambath is used again.
PROG 1 and PROG 2 feature
PROG 1 and PROG 2 keys program and store
preferred settings.
To program preferred settings: Press a PROG1
or PROG2 key. Enter the preferred time and
temperature settings. The TEMPO/PLUS™
will store these settings.
To select PROG1 or PROG2 : Press ON then
press PROG1 or PROG2. The steambath will
begin to operate at the stored settings.
TEMPO/PLUS
®
Operating Instruction
To Next Page
Loading...
Need help?
General