MSA Altair Pro Quick Start Guide-Setup

Scroll through menu displays.
Gas detector is ready for use.
Begin Setup Here
Activating the ALTAIR Pro Single Gas Detector

Need to change factory set points?  Turn page over

Activate/Turn-on  See inset below

Fresh-Air Setup  Turn page over

PRESS and HOLD the TEST button
for
5 seconds until ON displays.
* ALTAIR Pro Single-Gas Detectors must be activated
within 6 months of manufacture.

MSA Altair Pro Specifications

General

Type	Single-Gas Detector
Display	LCD
Ingress Protection	IP67
Sensor Options	Carbon Monoxide (CO), Hydrogen Sulfide (H2S), Oxygen (O2)
Sensor Type	Electrochemical
Alarm	Audible, Visual, Vibrating
Operating Temperature	-20°C to 50°C
Data Logging	Event logging