MSA Altair Quick Start Guide

RELEASE the button and PRESS
once AGAIN to activate.
Wait while the ALTAIR Detector
performs a 99-second activation
countdown.
Activating the ALTAIR Single-Gas Detector

Need to change factory set points?  Turn page over

Activate/Turn-on  See inset below

Fresh-Air Set-up  Turn page over
PRESS and HOLD the TEST
button for 5 seconds until ON
and ?display.
Begin Setup Here

* ALTAIR Single-Gas Detectors must be activated
within 6 months of manufacture.
0802-75-MC_AltairQuickStart_Layout 1 1/18/11 9:35 AM Page 1

MSA Altair Specifications

General

Gases Detected	Carbon Monoxide (CO), Hydrogen Sulfide (H2S), Oxygen (O2)
Display	LCD
Alarm Type	Visual, audible, and vibration alarms
Ingress Protection	IP67
Sensor Type	Electrochemical
Operating Temperature	-20°C to 50°C (-4°F to 122°F)