MSA DR-209M - Page 23

Universal digital repeater
DR-209M
Page 23
Table 12 – Parameters of tab page Measurement units
Name
Function
Speed vessel
Setting of data measurement units, selected from the drop down list:
knots, m/s, km/h, mph, mph(st), m, km, ft, mile, fathom, mille (st),
inch, dg/min, dg/sec, kPa, Pa, hPa, mmHg, inHg °С, °F
Distance
Deviation
Depth
Rotation speed
Pressure
Wind speed
Temperature
Correction data:
Depth
To ensure settings of correction data of the relevant parameters
Heading
Wind direction
Time to GPS
Heel
Pitch
Heave
ОК
To confirm the select
Apply
To apply the selected settings
Cancel
To cancel the selected settings
Along with the settings of measurement units in this tab, a user can also set up the
correction values, which are added to the specific parameters automatically. For example,
to correct the value of measured keel depth, the user shall enter correction value of dis-
tance from keel to water surface (water line).
Correction values are entered into the fields on the right. Once the required char-
acteristic is selected, the numeric panel opens, see Figure 15, using which the user can set
the relevant correction value.
Figure 15 – Tab page Measurement units with numeric panel