MSA DR-209M - Page 34

Operating manual
Page 34
To set up a transmitter index for each NMEA sentence, use a drop-down
keyboard / panel which appears after you press Transmitter index. The description of
keyboard is represented in Table 22.
Table 22 – The description of letters on the panel
Name
Function
«A»… «Z»
To add a relevant letter / symbol to an entry field
«
Х
»
To delete one letter / symbol from the left in the highlighted entry
field
« »
To confirm the changes and hide the panel
If a selected NMEA parameter shall be transmitted from the Primary source, put
a tick in a drop-down list opposite «1». If a selected NMEA parameter shall be transmitted
from the Secondary source, put a tick in a drop-down list opposite «2».
Provide these steps for all parameters.
If a selected NMEA parameter shall be excluded from the sentence, put a tick
opposite «–», and the parameter will be ignored by the system during reception / trans-
mission.
2.3.13.3 Individual settings for each port
Baud rate of reception / transmission, parity and stop bits can be also configured
for each port in Ports tab page.
The controls for settings of data reception / transmission are represented in
Table 23.
Table 23 – The controls for settings of data reception / transmission
Name
Function
ОК
To confirm the select
Apply
To apply the selected settings
Cancel
To cancel the selected settings
460800
To set up reception / transmission baud rate
230400
115200
57600
38400
28800
19200
14400
9600
4800
None
To set parity None/Even/Odd
Even
Odd