MSA FieldServer BACnet Router - Change User Management Settings

12.2 Change User Management Settings
• From the FS-GUI page, click Setup in the Navigation panel.
• Click User Management in the navigation panel.
NOTE:If the passwords are lost, the unit can be reset to factory settings to reinstate the default unique
password on the label. For recovery instructions, see the FieldServer Next Gen Recovery document. If the
default unique password is lost, then the unit must be mailed back to the factory.
NOTE:Any changes will require a FieldServer reboot to take effect.
• Check that the Users tab is selected.
User Types:
Admin – Can modify and view any settings on the FieldServer.
Operator – Can modify and view any data in the FieldServer array(s).
Viewer – Can only view settings/readings on the FieldServer.
46 BACnet Router Start-up Guide