4. Pass the strap over the
bar and back through
the buckle.
Installing the Chest Strap
Chest Strap Kit: P/N 10012167
Connect male and female ends of chest strap.
1. Extend the chest
straps.
2. Lay the unconnected
male end under the
right shoulder strap.
3. Lay the unconnected end of the male chest strap
under the left shoulder strap.
4. Pass the end through
the tunnel in the strap.
5. Lace the strap through
the slide buckle.
a. Lace the chest strap
over the bar and
down through the
slide buckle.
b. Pull the chest strap
through.
6. Don the Carrier/Harness Assembly to check chest
strap installation.
TAL 8012 (L) Rev. 2 - 10093081
8
FIREHAWK M7 CARRIER AND HARNESS ASSEMBLY
To Next Page
Loading...
