Chapter 3
3-10
External Cache
This allows you to turn on or off L2 (Level 2) cache memory for CPU.
Settings are Enabled (default) and Disabled.
Processor Number Feature
This option is for Pentium
®
III processor only. During Enabled, this will
check the CPU Serial number. Disable this option if you dont want the
system to know the serial number.
Quick Power On Self Test
The option speeds up Power On Self Test (POST) after you power on the
computer. When setting the item to Enabled, BIOS will shorten or skip
some check items during POST. Settings are Enabled and Disabled.
Default value is Disabled.
ATA/100 & SCSI Boot Order
The field allows you to determine the boot priority of the attached SCSI card
and Promise IDE RAID device when First, Second or Third Boot Device is
set to SCSI. Settings are ATA, SCSI and SCSI, ATA. Default value is ATA,
SCSI.
First/Second/Third Boot Device
The items allow you to set the sequence of boot devices where BIOS
attempts to load the disk operating system. The settings are:
HDD-0 The system will boot from the first HDD.
HDD-1 The system will boot from the second HDD.
HDD-2 The system will boot from the third HDD.
HDD-3 The system will boot from the fourth HDD.
Floppy The system will boot from floppy drive.
ZIP100 The system will boot from ATAPI ZIP drive.
LS120 The system will boot from LS-120 drive.
SCSI The system will boot from the SCSI.
LAN The system will boot from the Network drive.
CDROM The system will boot from the CD-ROM.
Disabled Disable this sequence.
To Next Page
Loading...
