MSI 694D Pro2 - Integrated Peripherals

Chapter 3
3-18
Integrated Peripherals
↑ ↓ → ←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
OnChip IDE Channel0 Enabled
OnChip IDE Channel1 Enabled
IDE Prefetch Mode Enabled
Primary Master PIO Auto
Primary Slave PIO Auto
Secondary Master PIO Auto
Secondary Slave PIO Auto
Primary Master UDMA Auto
Primary Slave UDMA Auto
Secondary Master UDMA Auto
Secondary Slave UDMA Auto
Init Display First PCI Slot
IDE HDD Block Mode Enabled
Onboard FDD Controller Enabled
Onboard Serial Port 1 Auto
Onboard Serial Port 2 Auto
UART 2 Mode Standard
IR Function Duplex Half
TX, RX inverting enable No, Yes
Onboard Parallel Port 378/IRQ7
Onboard Parallel Mode Normal
ECP Mode Use DMA 3
Parallel Port EPP Type EPP1.9
CMOS Setup Utility - Copyright(C) 1984-2000 Award Software
Integrated Peripherals
Item Help
Menu Level !
x
x
OnChip IDE Channel0/1
The integrated peripheral controller contains an IDE interface with support
for two IDE channels. Choose the default value Enabled to activate each
channel separately.
IDE Prefetch Mode
The onboard IDE drive interface supports prefetching, for faster drive
accesses. Set to Disabled if your primary and/or secondary add-in IDE
interface does not support prefetching.
Primary/Secondary Master/Slave PIO
The four fields allow you to set a PIO (Programmed Input/Output) mode for
each of the four IDE devices that the onboard IDE interface supports.