Chapter 3
3-20
ASKIR Amplitude Shift Keyed Infrared Port
IR Function Duplex
This field specifies a duplex value for the IR device connected to COM Port.
Full-Duplex mode permits simultaneous two-direction transmission. Half-
Duplex mode permits transmission in one direction only at a time. Settings
are Half and Full. The default is Half .
TX, RX inverting enable
This item allows you to enable the TX, RX inverting which depends on
different H/W requirement. It is not recommended to change the default
setting to avoid any error in your system. Settings are No, Yes (default),
Yes, No, Yes, Yes and No, No.
Onboard Parallel Port
This specifies the base I/O port address and IRQ for the onboard Parallel
Port. Settings are 378/IRQ7, 278/IRQ5, 3BC/IRQ7 and Disabled. Default
is 378/IRQ7.
Onboard Parallel Mode
This item selects the operating mode for the parallel port: Normal, EPP, ECP
or ECP/EPP. Default is Normal.
ECP Mode Use DMA
This item specifies a DMA channel 1 or 3 for the Parallel Port when it is set
to ECP or ECP/EPP mode.
Parallel Port EPP Type
The item selects the EPP version used by the parallel port if the port is set to
EPP or ECP/EPP mode. Settings are EPP1.7 and EPP1.9.
To Next Page
Loading...
