Chapter 4
4-4
Driver Installation for Windows
®
2000
Installing VIA® Chipset Driver
1. Insert the supplied CD disk into the CD-ROM drive.
2. The CD will auto-run and the setup screen will appear.
3. Click on Via Chipset Drivers and the screen will show VIA Service
Pack 4.XX.
4. Click Next and the screen will show a VIA Service Pack 1 README
dialog box.
5. Click Ye s and the screen will show three drivers: VIA Bus Master
Ultra ATA Driver (Windows 2000), AGP VxD Driver and VIA INF
Driver 1.XX. Select all and click Next to proceed.
6. The screen will show a VIA Bus Master Ultra ATA Driver dialog
box. Select Install and then click on Next.
7. The screen will show a VIA GART AGP Driver 4.XX dialog box.
Select Install AGP 4X/133 driver and click Next.
8. There is a Read Only File Detected dialog box. Click Ye s. A dialog
box Digital Signature Not Found will appear and ask Do you want
to continue the installation of the VIA Bus Master Ultra ATA
Controller. Click Ye s to continue.
9. Select Ye s and then click Finish to restart the system.
10. After restart, the system will find a new hardware device and the
Found New Hardware Wizard dialog box will appear. Click Next to
the next screen and a VIA BM Ultra DMA Channel device will be
found.
11. Click Next and the driver search result will be shown on the screen.
Click Next.
12. A dialog box Digital Signature Not Found will appear. Click Ye s .
13. Click Finish and then click Ye s to restart the system.
14. Repeat Step 10 through Step 13 again.
15. After restart, the VIA Chipset driver installation will be complete.
To Next Page
Loading...
