To Next Page

To Previous Page

Overview of Components

JCI1: Chassis Intrusion Connector

This connector allows you to connect the chassis intrusion switch cable.

Normal

(default)

Trigger the chassis

intrusion event

Using chassis intrusion detector

1. JCI1 connector to the chassis intrusion switch/ sensor on the chassis.

2. 

3. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.

4. Set Chassis Intrusion to Enabled.

5. Press F10 to save and exit and then press the Enter key to select Yes.

6. Once the chassis cover is opened again, a warning message will be displayed on

screen when the computer is turned on.

Resetting the chassis intrusion warning

1. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.

2. Set Chassis Intrusion to Reset.

3. Press F10 to save and exit and then press the Enter key to select Yes.

Questions and Answers:

Need help?

Do you have a question about the MSI GAMING EDGE WIFI MPG Z590 and is the answer not in the manual?

MSI GAMING EDGE WIFI MPG Z590 Specifications

General