52
Sets the FCLK frequency (Internal Data Fabric clock of DRAM). Please note the
overclocking behavior is not guaranteed.
Sets UCLK (Internal memory controller clock) mode.
It can improve memory compatibility or performance by choosing optimized memory
preset. This item will be available when the installed processor supports this function.
Enables or disables the system reboot function when the memory OC retry fails.
Enables or disables the initiation and training for memory every booting.
[Auto] The setting will be configured automatically by BIOS.
[Enabled] System will completely keep the archives of first intiation and training
for memory. So the memory will not be initialed and trained when
booting to accelerate the system booting time.
[Disabled] The memory will be initialed and trained every booting.
Press Enter
memory channel. The system may become unstable or unbootable after changing
memory timing. If it occurs, please clear the CMOS data and restore the default
settings. (Refer to the Clear CMOS jumper section to clear the CMOS data, and enter
the BIOS to load the default settings.)
Press Enter
conditions about voltage/ current/ temputure for CPU.
These options allows you to set the voltages related to CPU. If set to , BIOS will
set these voltages automatically or you can set it manually.
These options allows you to set the voltages related to memory. If set to , BIOS
will set these voltages automatically or you can set it manually.
Press Enter
installed CPU. You can also access this information menu at any time by pressing [F4].
Read only.
Press Enter
timings of installed memory. You can also access this information menu at any time by
pressing [F5].
To Next Page
Loading...
