Chapter 2
2-4
Overclocking
This motherboard is designed to support overclocking.
However, please make sure your components are able to
tolerate such abnormal setting, while doing overclocking.
Any attempt to operate beyond product specifications is
not recommended. We do not guarantee the damages or
risks caused by inadequate operation or beyond product
specifications.
WARNING!
CPU Clock Selection
To make a 100MHz CPU run at 100MHz or a 133MHz CPU run at 133MHz,
you need to adjust the CPU clock frequency through the jumper JFSB1.
For more information on the issue, refer to CPU Clock Selection Jumper:
JFSB1 later in this chapter.
CPU Core Speed Derivation Procedure
If CPU Clock = 100MHz
Core/Bus ratio = 7
then CPU core speed = Host Clock x Core/Bus ratio
= 100MHz x 7
= 700MHz
To Next Page
Loading...
