2-12
MS-7067 M-ATX Mainboard
Hard Disk Connectors: IDE1 & IDE2
The mainboard has an Enhanced PCI IDE and Ultra DMA 33/66/100 controller
that provides PIO mode 0~4, Bus Master, and Ultra DMA 33/66/100 function. You can
connect up to four hard disk drives, CD-ROM, 120MB Floppy (reserved for future
BIOS) and other devices.
IDE1 (Primary IDE Connector)
The first hard drive should always be connected to IDE1. IDE1 can connect a Master
and a Slave drive. You must configure second hard drive to Slave mode by setting the
jumper accordingly.
IDE2 (Secondary IDE Connector)
IDE2 can also connect a Master and a Slave drive.
MSI Reminds You...
If you install two hard disks on cable, you must configure the second
drive to Slave mode by setting its jumper. Refer to the hard disk docu-
mentation supplied by hard disk vendors for jumper setting instructions.
CD-In Connector: CD_IN
The connector is for CD-ROM audio connector.
CD_IN
GND
RL
IDE2 IDE1
To Next Page
Loading...
