2-7
Hardware Setup
Memory
The mainboard provides two 240-pin non-ECC DDRII 533/667 DIMMs and supports up
to 2GB system memory.
For more information on compatible components, please visit http://www.msi.com.tw/
program/products/mainboard/mbd/pro_mbd_trp_list.php.
64x2=128 pin 56x2=112 pin
DDRII
240-pin, 1.8V
Single-Channel: All DIMMs in GREEN
Installing DDRII Modules
1. The memory module has only one notch on the center and will only fit in the right
orientation.
2. Insert the DIMM memory module vertically into the DIMM slot. Then push it in until the
golden finger on the memory module is deeply inserted in the socket.
3. The plastic clip at each side of the DIMM slot will automatically close.
Volt
Notch
Important
You can barely see the golden finger if the module is properly inserted in the
socket.
To Next Page
Loading...
