NOTE: It is recommended to fill the spa with lukewarm water for quick heating and energy saving. Using tap water for spa filling to minimize the influence of
unwanted content, such as minerals.
NOTE: Ensure the manometer points to the Green section when the spa is filled with water.
NOTE: Always keep the spa cover on to minimize heat loss when heating the water.
Make sure the cover, and mostly its side facing water, will not come into contact with the ground or any other dirt when not in use.
Covers shall be cleaned inside and out periodically using a suitable solution that includes adequate disinfection (e.g. 10mL/L of free Chlorine).
WARNING:
Do not drag the spa after filling it with water.
Do not operate the spa until the water reaches the Minimum line.
The water temperature should not be higher than 40°C / 104°F.
Buckle Lock Operation
10
6 7
Make sure the filter cartridge remains in place when the spa is
filled with water.
Lock Unlock
CONTROLLER OPERATION
Heater Button
LED Display
Bubble Button
Up Button
Filter Button
Timer Button
Down Button
UVC Button
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
°C
°F
UVC
®
®
®
To Next Page
Loading...
Need help?
General
