12
FIRST USE AND SET-UP PREPARATION
The spa can be installed indoor and outdoor. For household use only.
The spa must be set up on a flat, smooth and supporting surface that is capable of supporting the
maximum load of the filled spa with listed maximum occupants.
Make sure the area is free of sharp objects under or around the spa. Uneven of unsound surfaces can
damage the spa and void your warranty. Level the surface before filling spa with water
Provide adequate drainage system around the spa to deal with overflow water and splashes.
Provide a properly located power outlet to connect the spa and allow easy access for period testing of the
cord mounted GFCI.
Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and / or service.
●
●
●
●
●
●
Site preparation and requirements
REF. NO. PARTS DESCRIPTION QTY.
NOTE: When ordering parts, be sure to quote the model number and part numbers.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
Spa cover with aluminum foil inside
(D-AL04/06; D-TE06; P-SH069 comes with a ground mat with the cover)
Spa tub
Wired controller
Heat preservation bubble mat (for P-CA049/069 / P-MB049/069)
Heat preservation foam mat (for P-EX049/069)
Digital lock (D-AL04/06; D-TE06; P-SH069 excepted)
Inflation hose for bladder
Spa drain valve adaptor
Repair kit
Spa cover inflatable bladder (for PREMIUM)
Wrench
Buckle spa cover and ground mat set
Warning label
1
1
1
1
1
1
1
1
1
1
1
1
1
1
DELIGHT: Filter cartridge*1, cartridge base
PREMIUM: Filter cartridge*2, cartridge base
To Next Page
Loading...
Need help?
General
