Why is my mspa Lite LS04U-NA not heating properly?
Your MSpa Hot Tub may not be heating properly for several reasons. The temperature might be set too low, so try setting a higher temperature. The filter cartridge could be dirty, so clean or replace it. Also, ensure the water level is at least at the minimum water line by adding more water. In case the filter pump doesn't work, refer to the "FILTER PUMP DOES NOT WORK" section.
What to do if my mspa Hot Tub is leaking?
If your MSpa Hot Tub is leaking, first tighten the in&outlet connection. If the spa is still leaking, ensure the drainage valve is completely closed. If the problem persists, repair any holes or splits in the spa pool body using the repair kit material.
How to stop my mspa Lite LS04U-NA Hot Tub from losing air?
If your MSpa Hot Tub is losing air, first check if the air valve is loose. Inflate the spa until the yellow section of the manometer is pushed out and ensure the valve is screwed tightly, replace it if necessary. Also, inspect the spa tub for holes or splits. Fill a squirt bottle with soapy water and spray on the seams. If there is a leak, small bubbles will come out. Clean and dry the leaking area, then use the repair patch supplied with your spa.
How to fix no display on the control panel of mspa Hot Tub?
If there is no display on the control panel of your MSpa Hot Tub, check the power socket. Change to a working socket or repair the existing one if it's faulty. Also, check if the PRCD is off and reset it by following the PRCD Testing section.
General| Control System | Digital Control Panel |
|---|---|
| Type | Inflatable Hot Tub |
| Temperature Range | Up to 104°F |
| Material | PVC |
| Voltage | 120V |
| Power Supply | 120V |
| Filter | Filter Cartridge |
To Next Page
