15
Note:
Before inflation , check whether the manometer cap is
screwed up tight on the valve of pool body. If not, please
tighten and then inflate. After inflation, the manometer
cannot be removed, otherwise the air will be released.
5
Spa Bladder Inflation.
5.1 Open the air valve (a) on the bladder. Insert the inflation
hose (b) into the valve. Open the air valve (C) on the spa
pool. Make sure you choose the correct one in black color.
5.2 Press the Bubble button to inflate until the bladder
is firm to touch but not hard.
5.3 Press Bubble button for more than 3 seconds to
turn off the function. Disconnect the inflation hose from the
air blower outlet and the valve.
5.4 Replace the air valve cap (c) back. Close and recess the
inflation valve (a).
5.
(a)
(b)
(c)
When the Yellow section is pushed out, the Spa inflation is completed. You can fill the Spa with water.
After water filling is completed, check the air pressure once again to ensure the manometer reaches its
Green section. Always ensure the manometer is in the Green section during use.
If the White section of the manometer appears, the spa is over inflated. Rotate the valve cap counter
clockwise, have the air released till the Green section is pushed out, then tighten it clockwise.
To avoid over inflation caused by warm weather or sunshine when leaving spa for weeks inflated and
filled with water in temperature higher than 68°F (20°C), please release some air to make sure the
manometer is always on in the Yellow section.
Green
Yellow
White
BUBBLE
BUBBLE
To Next Page
Loading...
Need help?
General
