6
● Always add chemicals to water, never add water to chemicals. Adding water to
chemicals may cause strong fumes or violent reactions and hazardous chemical
spray.
● For water already used, discharge it in time or use water chemicals for cleaning.
Usually, it is recommended to drain and refill the spa with clean water every 3-5
days.
● Use Mspa chemical kit for disinfection in accordance with manufacturer’s
instructions.
● Do not leave or set up the spa in temperature lower than 4°C (39°F) if heater is
not operating.
● Always enter and exit the spa or hot tub slowly and cautiously. Caution of wet
floor.
● To avoid damage to the pump, never turn on the spa or hot tubs unless it is
filled with water to the minimum water line.
● Place the spa or the hot tub only on a properly prepared site that can withstand
the floor loading requirement of the spa.
! CAUTION
● Never pour water with a temperature higher than 40°C (104°F) directly into the
spa.
● Always unplug this product from the electrical outlet before removing, cleaning,
servicing, or making any adjustment to the product.
● Never jump or dive into a spa or any shallow body of water.
● No part of the electric appliance is to be located above the bath during use.
● Do not bury the electrical cord. Locate the cord where it will not be damaged by
lawn mowers, hedge trimmers, and other equipment.
● Do not attempt to plug in or unplug this product while standing in water or when
your hands are wet.
● Do not use the spa if damaged during the delivery and/or malfunctioning in any
way. Contact info@doh-brands-group.de for further direction.
● Keep all pets away from the spa to avoid any damage.
● Do not add bath oil or bath salts to the spa water.
To Next Page
Loading...
