BUBBLE AIR
BLOWER DOES
NOT WORK
Bubble motor failure
Auto-off 10 minute
Contact the MSpa Service Center
FILTER PUMP
DOES NOT WORK
Power failure Check the power supply
Clean or replace filter cartridge
23
Insufficient filtering time
Dirty filter cartridge
Improper water maintenance
Extend filtration time
Clean or replace the filter cartridge in time
SPA LOOSES AIR
WATER NOT
CLEAN
Air valve got loosen
Hole or split on the spa tub
Put soap water in a squirt bottle and spray
on seams. If there is a leak, small bubbles
will come out. After you find the leak, clean
and dry the leaking area, then use the repair
patch comes with your spa to repair. Check
the repair section on P20
Inflate the spa till Yellow section of the
manometer is pushed out. Make sure the
valve is screwed tightly. Replace the valve if
necessary.
SPA TUB IN AN
ABNORMAL
SHAPE
Extra air pressure by strong
sunshine
Please check the air pressure and release
air if necessary
During hot weather, it recommended to
check if it is necessary to release some air to
avoid any possible damage to the spa pool
CONTACT YOUR LOCAL MSPA DEALER OR SERVICE CENTER FOR ANY PRODUCT RELATED QUESTIONS OR PROBLEMS.
Waiting for 10 minutes and turn on the
Bubble button again
Low water level
Filter cartridge stuck by dirt
or other objects
Refer to the chemical manufacture’s
instruction
Add more water to reach the minimum
water line
PROBLEM CAUSE SOLUTION
To Next Page
Loading...
