mspa Lite Orbit User Manual

NOTE: Your spa will require additional air to be added from time to time. Changes in temperature from day to night will change the pressure in the spa and
may cause a certain amount of deflation.
Ensure the manometer points to the Yellow section in the following conditions
After inflation, before filling the water.
When leaving the spa outdoors unattended for long periods of time at a temperature higher than 20°C (68°F).
Ensure the manometer points to the Green section in the following conditions
When the spa is filled with water.
When the spa is in use.
WARNING: If the manometer points to the White section, the air pressure of your spa is too high.
Press the black button on the bottom of manometer to release some air until the pointer returns to the Green
or Yellow section.
IMPORTANT: ALWAYS READ THE MANOMETER TO ENSURE THAT THE SPA IS FILLED AT THE CORRECT AIR PRES-
SURE FOR THE CONDITIONS.
9
SPA SET-UP
Make sure the inflation hose is properly installed as pictured above.
Disconnect the inflation. Rotate the air valve cap back.
Press the BUBBLE button for inflation.
1 2 3
BUBBLE
Press it again to stop inflation when the
manometer points to the YELLOW section.
4 5
YELLOW
YELLOW
YELLOW
GREEN
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
YELLOW
GREEN
WHITE
●
●
●
●
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
°C
°F

mspa Lite Orbit Specifications

General

Brand	mspa
Model	Lite Orbit
Category	Hot Tub
Language	English