What to do if there is no display on the mspa Naval Hot Tub control panel?
If the control panel on your MSpa Hot Tub has no display, begin by checking the power socket; it may have failed and needs repair or replacement. If the socket is functional, reset the PRCD following the PRCD Testing section.
How to clean MSpa Hot Tub water?
If your MSpa Hot Tub water is not clean, try these steps: change the water if it has been used for a long time. Increase the filtration time. Clean or replace the filter cartridge promptly. For proper water maintenance, refer to the chemical manufacturer’s instructions.
What to do if filter pump does not work on mspa Naval Hot Tub?
If the filter pump on your MSpa Hot Tub isn't working, first, check the filter cartridge for clogs caused by dirt or other objects, and clean or replace it. If the filter system has failed, contact the MSpa Service Center.
Why bubble air blower does not work on mspa Naval?
If the bubble air blower on your MSpa Hot Tub isn't working, wait for 10 minutes and try turning the Bubble button on again, as it may have auto-off after 10 minutes. If it still doesn't work, the internal parts might be damaged, and you should contact the MSpa Service Center.
What to do if my MSpa Hot Tub is leaking?
If your MSpa Hot Tub is leaking, start by checking the in&outlet connections to ensure they are securely tightened. Also, verify that the drainage valve is completely closed. If water is leaking from the spa pool body itself, use the repair kit material to patch any holes or splits.
What causes ozonator failure in my MSpa Hot Tub?
If the ozonator fails in your MSpa Hot Tub, ensure the water level is at least at the minimum line by adding more water. If the issue continues, the one-way valve may be blocked, or the filter pump may not be working, requiring you to contact the MSpa Service Center or refer to the "FILTER PUMP DOES NOT WORK" section.
What to do if there is no display on my mspa Naval Hot Tub wired controller?
If your MSpa Hot Tub's wired controller has no display, first check the power supply. If that's fine, reset the PRCD following the PRCD Testing section. If the PRCD is broken or the control panel doesn't display after pressing the reset button, contact the MSpa Service Center.
How to fix a leaking MSpa Hot Tub?
If the MSpa Hot Tub is leaking, ensure the spa inlet/outlet connections are securely tightened. If water leaks from the spa liner, repair the hole with the repair kit material. If the drainage valve is not closed completely, contact the MSpa Service Center.
How to fix no display on MSpa Hot Tub control panel?
If there's no display on your MSpa Hot Tub's control panel, first, try using a different power socket or have the current one repaired. If that doesn't work, reset the PRCD following the PRCD Testing section. If the controller still doesn't display after pressing the Reset button, or if the PRCD is broken, contact the MSpa Service Center.
What does error E1 mean on my mspa Naval?
If your MSpa Hot Tub displays an E1 error, it could be due to a water flow switch failure, in which case you should contact the MSpa Service Center. Alternatively, the water level might be below the minimum line, so add water above the minimum line. Filter failure can also cause this error.
To Next Page
General
