What to do if mspa Naval Hot Tub is leaking?
If your MSpa Hot Tub is leaking, first, tighten the in&outlet connection. If the leak persists, ensure the drainage valve is completely closed. If it continues to leak, contact the MSpa Service Center. If water is leaking from the spa pool body, repair the hole or split using the repair kit material.
Why is my mspa Naval not heating properly?
If your MSpa Hot Tub isn't heating properly, first, make sure the temperature is set high enough. Then, check the filter cartridge and clean or replace it if it's dirty. Also, ensure the water level is at least at the minimum line. If these steps don't resolve the issue, and the filter pump isn't working, refer to the "FILTER PUMP DOES NOT WORK" section. If the heater has failed, contact the MSpa Service Center.
How to fix my mspa Naval Hot Tub that loses air?
If your MSpa Hot Tub is losing air, ensure the air valve is tightly screwed in; replace it if necessary and inflate the spa to 12 PSI. Also, inspect the spa tub for holes or splits. To find leaks, apply soapy water to the seams; bubbles will appear where there's a leak. Clean and dry the area before applying the provided repair patch.
What does error E1 mean on my mspa Naval?
If your MSpa Hot Tub displays an E1 error, it could be due to a water flow switch failure, in which case you should contact the MSpa Service Center. Alternatively, the water level might be below the minimum line, so add water above the minimum line. Filter failure can also cause this error.
Why does the bubble air blower on my mspa Naval not work?
If the bubble air blower on your MSpa Hot Tub doesn't work, wait for 10 minutes in case it auto-off after 10 minutes. If the issue persists, the unidirectional threshold might not be open or there could be a control panel failure, requiring you to contact the MSpa Service Center.
What to do if the filter pump on my MSpa Hot Tub doesn't work?
If the filter pump on your MSpa Hot Tub isn't working, start by cleaning or replacing the filter cartridge if it's clogged with dirt or other objects. If this doesn't solve the problem, there may be a filter system failure, requiring you to contact the MSpa service center.
Why is the water in my mspa Naval not clean?
If the water in your MSpa Hot Tub is not clean, change the water if it has been used for too long. Also, increase filtration frequency if filtering is insufficient. If the filter cartridge is dirty, clean or replace it in time. For improper water maintenance, refer to the chemical manufacturer's instructions.
Why is my mspa Naval losing air?
If your MSpa Hot Tub (Mono) is losing air, first check the air valve to ensure it's screwed tightly. If necessary, replace the valve and inflate the spa to 12 PSI. If the issue persists, there may be a hole or split in the spa tub. To locate it, apply soapy water to the seams; bubbles will appear where there's a leak. Clean and dry the area before applying the repair patch provided with your spa.
What to do if my MSpa Hot Tub is leaking?
If your MSpa Hot Tub is leaking, start by checking the in&outlet connections to ensure they are securely tightened. Also, verify that the drainage valve is completely closed. If water is leaking from the spa pool body itself, use the repair kit material to patch any holes or splits.
Why bubble air blower does not work on mspa Naval?
If the bubble air blower on your MSpa Hot Tub isn't working, wait for 10 minutes and try turning the Bubble button on again, as it may have auto-off after 10 minutes. If it still doesn't work, the internal parts might be damaged, and you should contact the MSpa Service Center.
To Next Page
General
