Need help?Do you have a question about the MTD 315E660G000 and is the answer not in the manual?
General| Stages | Single-Stage |
|---|---|
| Clearing Width | 21 inches |
| Throw Distance | Up to 30 ft |
| Auger Material | Steel |
| Chute Control | Manual |
Read owner's guide, understand controls, and follow safety rules before operating.
Inspect area, remove debris, wear appropriate clothing, and check fuel before operation.
Key safety rules for operating the snow thrower during use.
Safety precautions related to maintaining and storing the snow thrower.
Hardware for attaching the snow thrower's handle assembly.
Components for attaching the chute assembly and crank.
Hardware for connecting the shift rod and clutch cables.
Information on shear bolts designed to protect the auger system.
Steps for unpacking, identifying parts, and required tools for assembly.
Detailed steps for attaching the snow thrower's handle assembly.
Instructions for attaching the chute assembly to the snow thrower.
Step-by-step guide for installing the chute crank mechanism.
Connecting the shift rod and clutch cables to the control system.
Ensuring proper tension and operation of the auger drive clutch cable.
Adjusting the traction drive clutch and shift lever for correct performance.
Adjusting skid shoes for optimal ground clearance and snow removal.
Setting the correct tire pressure for pneumatic tires.
Understanding and using the shift lever for ground speed control.
How to engage and disengage auger and traction drive clutches.
Using the chute crank to change snow discharge direction.
Procedures for filling the fuel tank and checking engine oil levels.
Detailed instructions for starting the engine via recoil or electric starter.
Safe procedures for shutting down the snow thrower engine.
How to engage the drive system for snow thrower movement.
Advice for efficient and safe snow removal.
Adjusting the chute angle for desired snow throw distance.
Adjusting skid shoes for ground clearance based on snow conditions.
Detailed procedure for adjusting the traction drive clutch.
Adjusting the auger clutch and shift rod for proper function.
Minor carburetor adjustments for optimal performance.
Adjusting drive wheels for one-wheel or two-wheel drive.
Recommended lubrication points and intervals for components.
Information on auger shear bolts and replacement.
Instructions for removing and replacing auger and drive belts.
Detailed steps for replacing the auger belt.
Procedure for replacing the main drive belt.
Steps for replacing worn or cracked friction wheel rubber.
Guidelines for preparing the snow thrower for long-term storage.
Procedures for fuel management and oil treatment for storage.
To Next Page
