Need help?Do you have a question about the MTD 31A-32AD762 and is the answer not in the manual?
General| Brand | MTD |
|---|---|
| Model | 31A-32AD762 |
| Category | Snow Blower |
| Language | English |
Expresses gratitude for purchasing the snow thrower and emphasizes reading the manual.
Instructs users to record model and serial number for support.
Provides contact options for assistance with assembly, operation, or maintenance.
Emphasizes reading, understanding, and following all instructions for safe operation.
Details pre-operation checks and area preparation for safe use.
Lists items included in the snow thrower packaging.
Provides step-by-step instructions for assembling the snow thrower.
Details the process of attaching the upper handle to the lower handle.
Explains the purpose and storage of shear pins.
Describes the location and use of the chute clean-out tool.
Advises on the type of gasoline and handling precautions.
Provides instructions and warnings for refueling the machine.
Explains how to adjust the skid shoes for different surfaces.
Details periodic adjustment of the auger control cable for proper function.
Describes how to engage and disengage the wheels for movement.
Explains the function of the ignition key as a safety device.
Identifies the component used to manually start the engine.
Explains the function of the auger when engaged.
Describes how snow is discharged from the auger housing.
Details how to engage and disengage the augers.
Explains how to adjust the distance snow is thrown.
Describes the function of the shave plate for close snow removal.
Explains how to position skid shoes based on surface conditions.
Describes how to use the fuel cap for refueling.
Explains how to check and add engine oil.
Identifies the location for draining engine oil.
States that engine exhaust exits via the muffler.
Describes how to activate the choke for cold starts.
Explains how to use the primer for cold-weather starting.
Details how the throttle regulates engine speed.
Identifies the handle used to manually start the engine.
Provides instructions for clearing snow from the chute assembly.
Step-by-step guide to starting the snow thrower engine.
Instructions for using the recoil starter correctly.
Procedures for safely shutting down the snow thrower engine.
How to engage and disengage the snow thrower's drive system.
How to engage and disengage the auger mechanism.
General safety and maintenance advice for the snow thrower.
Lists general recommendations for engine upkeep.
Advises on checking and maintaining tire pressure.
Instructions for checking the condition of drive belts.
Guidance on checking and replacing wear items.
Steps for properly storing the snow thrower for extended periods.
Details lubrication points for controls and auger shaft.
Instructions for lubricating the auger shaft and bearings.
Guidance on removing, cleaning, and lubricating wheels.
Outlines tasks and intervals for engine maintenance.
Step-by-step process for draining and refilling engine oil.
Advises on the correct type and viscosity of engine oil.
Provides advice on cleaning the engine, avoiding water spray.
Details fuel draining and engine preparation for storage.
Explains how to check and replace auger shear pins.
Instructions for removing the belt cover and replacing belts.
Specific steps for removing and replacing the auger belt.
Lists causes and remedies for engine starting issues.
Provides solutions for an engine that runs inconsistently.
Offers troubleshooting steps for an overheating engine.
Addresses potential causes and fixes for reduced engine power.
Outlines checks for excessive vibration and potential damage.
Troubleshooting steps if the unit does not move forward.
Addresses issues where augers rotate when not engaged.
Solutions for when the snow is not being discharged properly.
Details the warranty coverage for emission control systems.
Outlines the owner's duties to maintain warranty coverage.
Specifies warranty requirements for defects in small off-road engines.
To Next Page