Need help?Do you have a question about the MTD 315E610E000 and is the answer not in the manual?
General| Intake Height | 16 inches |
|---|---|
| Drive System | Friction disc |
| Stages | Single-Stage |
| Chute Control | Manual |
| Clearing Width | 21 inches |
| Start Type | Recoil |
| Engine Type | 4-Cycle |
| Throw Distance | Up to 30 ft |
| Starter Type | Recoil |
| Skid Shoes | Adjustable |
Read guide, understand controls, and proper use before operating.
Inspect area, remove objects, and prepare equipment before starting operation.
Follow safety guidelines for safe operation, including hand/foot placement and caution.
Regular checks, proper storage procedures, and engine cool-down are essential.
Remove staples, cut carton, lay flat, and check for loose parts before discarding.
Securely attach the left and right handles and handle panel using specified hardware.
Grease chute opening and secure assembly using screws, washers, and nuts.
Attach the chute crank to the upper bracket and lower bracket using specified hardware.
Insert ferrule, secure shift rod with washers and hairpin clips for proper connection.
Connect clutch cables to grips, ensuring no slack to maintain safety features.
Locate shift lever on handle panel; use to select forward or reverse ground speed.
Engage augers by squeezing clutch grip; release to stop snow throwing action.
Engage wheel drive with clutch grip; this lever also locks auger clutch.
Turn chute crank clockwise for left discharge, counterclockwise for right discharge.
Service engine with gasoline and oil as instructed in separate engine manual.
Instructions for optional electric starter operation and safety precautions.
Steps for starting the engine using recoil or optional electric starter.
Procedures for safely stopping the engine and preventing freeze-up.
How to engage forward or reverse drive using the shift lever and traction drive clutch grip.
Allow engine to warm up, be aware of hot muffler, and use appropriate tire chains.
Adjust chute angle by loosening hand knob to control snow throw distance.
Adjust skid shoes for desired ground clearance based on snow conditions.
Refer to Final Adjustment section for auger clutch adjustment instructions.
Adjust shift rod by removing hairpin clip and washer, then following assembly instructions.
Adjust traction drive clutch by loosening lock nut on cable and threading as necessary.
Lubricate gear shaft, shift mechanism, cams, gear case, and bearings as per recommendations.
Adjust drive wheels for one-wheel or both-wheels driving by placing klick pins in specific holes.
Auger shear bolts can shear on impact; replacement bolts and nuts are provided.
Shave plate and skid shoes are subject to wear and should be checked and replaced periodically.
Remove belt cover, drain gas, tip unit, and remove belts to change them.
Follow steps to remove and replace drive belt, ensuring support bracket rests on stop bolt.
To Next Page
