B
Bruce CurryAug 1, 2025
What to do if MTD Edger drive belt slips?
- WWesley JonesAug 1, 2025
If the drive belt slips, it might be worn or stretched. In this case, replace the drive belt.
To Next PageTo Next PageWhat to do if MTD Edger drive belt slips?
If the drive belt slips, it might be worn or stretched. In this case, replace the drive belt.
Why MTD 520 Edger engine fails to start?
The engine may fail to start due to several reasons: * The fuel tank may be empty: fill the tank with clean, fresh gasoline. * There may be stale fuel in the gasoline tank: drain the gasoline and refill the tank with clean, fresh gasoline. * The spark plug wire may be disconnected: connect the spark plug wire to the spark plug. * The spark plug may be fouled: clean, adjust the gap, or replace the spark plug. * The engine may need to be primed: push the primer bulb two or three times.
What to do if MTD Edger engine runs erratic?
If the engine runs erratically, consider the following: * The spark plug wire might be loose: connect and tighten the spark plug wire. * There might be stale fuel in the gasoline tank: drain the gasoline and refill the tank with clean, fresh gasoline. * The vent in the gas cap could be plugged: clear the vent of any debris. * There may be water or dirt in the fuel system: drain the fuel tank and refill it with fresh fuel.
Why MTD 520 engine overheats?
The engine may overheat due to: * Low engine oil level: fill the crankcase with proper oil. * Restricted airflow: clean the area around the engine’s cooling fins. * Dirty air filter: replace the engine’s air filter.
Why MTD Edger has excessive vibration?
Excessive vibration can occur if the edger blade is bent or damaged. Replace the edger blade.
Information on contacting customer support via website and phone.
Instructions for safe operation training.
Steps for preparing the machine before use.
Guidelines for operating the machine safely.
Procedure for grounding the engine's spark plug.
Steps for positioning and securing the edger handles.
Procedure for attaching the starter rope to the edger.
Description of the blade control bail's function.
Explanation of the blade depth control lever.
Function of the bevel adjustment lever.
How to use the curb height adjustment lever.
Instructions for adding gasoline and oil to the engine.
Step-by-step guide to starting the edger engine.
Procedure for stopping the edger's engine.
Setting the bevel adjustment lever for edging.
Instructions for using the trenching feature.
Setting the bevel adjustment lever for beveling.
Lubrication points for the edger.
Procedure for replacing the edger blade.
General
