EasyManua.ls Logo

MTD Yard Machines 580 Series - User Manual

MTD Yard Machines 580 Series
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Edger
Model Series 580
OPERATOR’S MANUAL
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized
service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.
PRINTED IN U.S.A.
FORM NO.
770-10397B.fm
(5/02)

Table of Contents

Questions and Answers

  • O
    ogarciaAug 11, 2025
    What to do if the drive belt slips on my MTD Yard Machines 580?
    • V
      Veronica AustinAug 11, 2025
      If the drive belt on your MTD Edger is slipping, it is likely worn or stretched and needs to be replaced. Replace the drive belt.
  • D
    Deborah McmillanAug 17, 2025
    How to fix MTD Yard Machines 580 that fails to start?
    • J
      John LucasAug 17, 2025
      If your MTD Edger fails to start, there are several potential causes. First, ensure the fuel tank is filled with clean, fresh gasoline. If the tank is full, stale fuel may be the issue; drain the old gasoline and refill. Check that the throttle control lever is in the FAST position. Make sure the spark plug wire is connected to the spark plug. Also, the engine may need to be primed, so push the primer bulb two or three times. If these steps don't work, the spark plug may be fouled and need cleaning, gap adjustment, or replacement. For a dirty air cleaner or other issues, refer to the Briggs & Stratton Operator/Owner Manual.
  • X
    xsmithAug 25, 2025
    What to do if MTD Yard Machines 580 Edger engine runs erratic?
    • P
      Patrick MedinaAug 25, 2025
      If your MTD Edger engine runs erratically, start by checking the spark plug wire to ensure it is securely connected and tightened. Stale fuel can also cause this issue, so drain the gasoline and refill the tank with clean, fresh gasoline. Also, check the vent in the gas cap and clear it of any debris. Water or dirt in the fuel system can be another cause; drain the fuel tank in this case. For a dirty air cleaner, clean it. If the issue persists and you suspect the carburetor is out of adjustment, refer to the Briggs & Stratton Operator/Owner Manual.
  • Q
    qramirezAug 29, 2025
    Why is my MTD Edger engine overheating?
    • J
      Jamie PetersonAug 29, 2025
      If your MTD Edger engine is overheating, check the engine oil level and fill the crankcase with the proper oil if it's low. Also, ensure that air flow is not restricted by cleaning the area around the engine’s cooling fins. Another potential cause is a dirty air filter, which should be replaced. If these steps don't resolve the issue and you suspect the carburetor is not adjusted properly, refer to the Briggs & Stratton Operator/Owner Manual.
  • K
    Kelsey GomezSep 5, 2025
    What causes excessive vibration in my MTD Yard Machines 580?
    • M
      Mr. Timothy PaulSep 5, 2025
      Excessive vibration in your MTD Edger can be caused by a bent or damaged edger blade. If this is the case, replace the edger blade. If the blade spindle is bent or damaged, contact an authorized MTD service dealer.

MTD Yard Machines 580 Series Specifications

General IconGeneral
BrandMTD
ModelYard Machines 580 Series
CategoryEdger
LanguageEnglish

Related product manuals