What to do if my MTD Log Splitter runs but wood won't split or splits too slowly?
If your MTD Log Splitter engine runs, but the wood will not split or splits too slowly, make sure that pump inlet hoses are clear and unblocked. Check the oil level. If the oil is contaminated, drain the oil, clean reservoir, and refill. Also, do not attempt to split wood against the grain.
Why drivebelt slips on MTD 24BF550E229 Edger?
A drivebelt on your MTD Edger might slip because the belt is worn or stretched. Replace the drive belt to resolve this issue.
How to fix occasional skips at high speed on my MTD Lawn Mower?
If your MTD Lawn Mower occasionally skips or hesitates at high speed, the spark plug gap may be too close. Adjust the gap, referring to the Engine Operator’s Manual for the correct gap specifications.
What to do if the drive-belt slips on my MTD Lawn Mower?
If the drive-belt slips on your MTD Lawn Mower, it is likely worn or stretched and needs to be replaced.
Why is my MTD Log Splitter pump shaft seal leaking?
If there is a leaking pump shaft seal on your MTD Log Splitter, it may be due to engine/pump misalignment. Correct alignment as necessary. Also, make certain the reservoir is properly vented.
Why MTD Log Splitter engine will not turn or stalls under low load conditions?
If the engine on your MTD Log Splitter will not turn or stalls under low load conditions, the issue could be: * Engine/pump misalignment. Correct alignment as necessary. * Hydraulic lines blocked. Flush and clean hydraulic system. * Blocked directional valve. Flush and clean hydraulic system.
Why MTD Log Splitter engine stalls during splitting?
If your MTD Log Splitter engine stalls during splitting, it might be due to an overloaded cylinder. Avoid attempting to split wood against the grain.
Why is the cylinder shaft speed slow on my MTD Log Splitter?
If the cylinder shaft speed is slow while extending and retracting on your MTD Log Splitter, it could be due to: * Excessive pump inlet vacuum. Make certain pump inlet hoses are clear and unblocked; use short, large diameter inlet hoses. * Incorrect oil level. Check the oil level. * Contaminated oil. Drain oil, clean reservoir and refill.
What causes excessive vibration in MTD 24BF550E229?
Excessive vibration in your MTD Edger can be caused by: * A bent or damaged edger blade; replace the edger blade. * A bent or damaged blade spindle.
What to do if MTD 24BF550E229 Edger engine runs erratic?
If your MTD Edger engine is running erratically, consider the following: * Check the spark plug wire and connect and tighten if loose. * Drain any stale fuel from the gasoline tank and refill with fresh fuel. * Ensure the vent in the gas cap isn't plugged; clear any debris. * Drain the fuel tank and refill with fresh fuel if there's water or dirt in the fuel system.
To Next Page
General
