MTD H Style 600 Series User Manual

SECTIONS: UNPACKING
Removing Unit From Carton
• Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open
carton.
• Remove loose parts if included with unit (i.e., owner's manual, etc.).
• Cut along dotted lines and lay carton down flat. Remove packing material.
• Roll or slide unit out of carton. Check carton thoroughly for loose parts.
NOTE: Make sure not to crimp the cables while removing the loose parts or the entire unit from the carton.
NOTE: Reference to right or left hand side of the mower and/or front or behind the mower is observed from
the operating position.
SECTION 6: CONTENTS OF HARWARE PACK
Locate the hardware pack shipped with your mower. The contents of this hardware pack are illustrated
below. For identification purposes, lay out the hardware from the bag and place these on the figure. The
hardware pack may contain extra items which are meant for maintenance jobs and not for the initial
assembly. Save these carefully for future use.
Attaching Front Wheels Attaching Rear Wheels (if not assembled)
6

MTD H Style 600 Series Specifications

General

Brand	MTD
Model	H Style 600 Series
Category	Snow Blower
Language	English