MTP 3100 - Introduction; Safety and Maintenance Information

www.mtpinc.com 1
INTRODUCTION / SAFETY
CAUTION! This symbol indicates that the operator must refer to an explanation in the Operating
Instructions to avoid personal injury or damage to the meter.
WARNING! It is recommended you contact a qualified electrician to install the clamps on the
electrical panel. We will not be held responsible for damage as a result of a wrong connection
which may cause injury or death.
1. Introduction
Congratulations on the purchase of your new smart wireless electricity monitor, Model MTP-3100. This
product was designed to help you monitor and better manage electricity consumption. This guide is aimed
at helping you in the set-up of the wireless monitoring system. Careful use of this device will provide years
of reliable service.
Please note this manual will refer to the below devices in the following manner:
Receiver
= Monitor (M)
Sender
= Transmit (T)
2. Safety and Maintenance Information
Before installation, please pay attention to the following information:
 Please read all instructions before you use the monitoring system.
 Please shake the display unit and the power transmitter first, before installation. Do not use if you hear
any loose parts and communicate with your authorized distributor for replacement.
 Do not allow children or people unfamiliar with these instructions use the system.
 Keep the monitor, transmitter and sensor clamp away from sources of heat, water or any other liquid.
 Place the monitor, transmitter and sensor clamp where children can not touch or pull.
 Do not try to disassemble or modify any parts of the monitoring system. In case of problem, please
consult your representative.
 Do not use the monitoring system if you find that your electric wire is in an abnormal condition, such as
loose wire, exposed copper wire, burnt mark on wire insulation layer, holes on wire layer or damage on
electric meter. In case of such abnormalities, please consult a professional electrician immediately.
 Periodically check all wires and components to ensure there is no damage.
 Use a dry cloth to clean. Do not use solvent, abrasive cleaners or water.
FCC Declaration of conformity: Tested to comply with FCC standards. This device complies with part 15 of the
FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, inlcuding interference that may cause
undesired operation. Complies with Industry Canada ES-003l.
This instrument conforms to UL STD # 61010-1 / # 61010-2 certified to CSA STD C22.2 # 61010-1 / # 61010-2