MTR+ Dolito - Page 35

Dolito Bedienungsanleitung / Operators Manual
35
2. By pressing the program button „P” you can choose from the programs 01 – 05
(pre-programmed).
3. This is followed by pressing the buttons „+/-” below the channel used. The selected program
runs automatically and the LCD displays the intensity as milliamps (mA).
Program
Remaining
Program Time
Mode
Intensity
Channel A
In the upper row you can see the remaining program time and in the bottom line the intensity
being applied to each channel. If the button „+” is pressed repeatedly the intensity of
stimulation increases. If the button „-” is pressed repeatedly the intensity of stimulation is
reduced. For the setting of the intensity it is vital that one feels the electric current but that
discomfort never occurs.
4. If you wish to interrupt the program, press the button „S” once and the program will pause.
The program will resume for the remaining program time when pressing this button once
again. In this case, the intensity increases within one second to the previous used value.
5. By pressing the „P“-button you pause as well, you can continue with new intensity
adjustment by pressing the +button. If you press „P“ a second time the program is nished.
6. Dolito is switched o when pressing the button „On/O” or automatically one minute after
the program is nished.
Intensity
Channel B