Installation
38 Series 505G2 SilentFlo™ Hydraulic Power Unit
Name and
Location
Description
Pressure Filter Not
Present/Pressure
Filter Present
Pushbutton /Indicator. This button is used to define if a pressure filter is
present.
Pressure Filter Not Present- gray: The HPU does not have a pressure
filter.
Pressure Filter Present- black: The HPU does have a pressure filter.
Temp Display In
(deg)
Part of the Analog
Option;only
displayed if the
Analog Option was
purchased.
Pushbutton/Indicator: Used to select temperature display in either
Celsius or Fahrenheit. Push to alternate between the two temperature
scales.
Temp Display in °F - gray.
Temp Display in °C - black.
Pressure Display
In (units)
Part of the Analog
Option;only
displayed if the
Analog Option was
purchased.
Pushbutton/Indicator: Used to select the units for pressure displays in
either psi or MPa. Push to alternate between the two pressure units.
Pressure Display in psi - gray.
Pressure Display in MPa - black.
Screen select
buttons
The Main, Status, and Setup pushbuttons/indicators are described in
the Main Screen section; refer to “Main Screen” on page 40.
The HMI Setup pushbutton/indicator is for MTS service personnel and
used to display a screen that is used to define factory settings such as
serial number and HMI software version.
To Next Page
Loading...
Need help?
General