7.6.2 Injector – Removal and installation
Preconditions
☑Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use Part No. Qty.
Socket wrench
0005896803/00 1
Puller
F6790629 1
Double-head box wrench
F30011450 1
Open-end wrench bit
F30025897 1
Box wrench
F30451199 1
Alignment device
F6790507 1
Grease(Kluthe Hakuform 30-11C)
X00059351 1
Engine oil
WARNING
Fuels are combustible.
Risk of fire and explosion!
• Avoid open flames, electrical sparks and ignition sources.
• Do not smoke.
Preparatory steps
1. Close off fuel supply to engine.
2. Remove cylinder head cover (→ Page 85).
Removing injector
1. Remove HP line (5) using socket wrench.
2. Disconnect injector cable (4).
3. Remove screw (2).
4. Take off hold-down clamp (3).
5. Remove injector (1) with puller.
6. Remove O-rings from injector.
7. Mask all connections and bores or seal
with suitable plugs.
M015590/06E 2014-03 | Task Description | 87
TIM-ID: 0000004650 - 003
To Next Page