EasyManua.ls Logo

MTU 8 V 2000 M9x - Charge-Air and Air Intake Systems

MTU 8 V 2000 M9x
157 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7.9 Charge-Air Cooling
7.9.1 Intercooler – Checking condensate drain line for coolant discharge and
obstruction
DANGER
Rotating and moving engine parts.
Risk of crushing, danger of parts of the body being caught or pulled in!
• Only run the engine at low power. Keep away from the engine's danger zone.
WARNING
High level of engine noise when the engine is running.
Risk of damage to hearing!
• Wear ear protectors.
WARNING
Compressed air gun ejects a jet of pressurized air.
Risk of injury to eyes and damage to hearing, risk of rupturing internal organs!
• Never direct air jet at people.
• Always wear safety goggles/face mask and ear defenders.
Intercooler – Checking conden-
sate drain line for coolant dis-
charge and obstruction
1. Check drain line for water discharge and
obstruction when the engine is running
idle.
2. If no air emerges, remove condensate drain
line and blow out with compressed air.
3. Replace obstructed drain line by new one.
4. Install condensate drain line.
5. If a large amount of coolant is continuously
discharged, the intercooler is leaking. Con-
tact Service.
Emergency measures prior to engine start with a leaking intercooler
1. Remove injectors (→ Page 86).
2. Bar engine manually (→ Page 74).
3. Crank engine on starting system to blow out combustion chambers (→ Page 75).
4. Install injectors (→ Page 87).
M015590/06E 2014-03
| Task Description | 99
TIM-ID: 0000027574 - 004

Table of Contents