I I . F D A w i t h p l a n e t a r y r e d u c i n g g e a r s ;
HPS with the cylinder in the steering
trapezium
Front wheel tractor track is adjusted within
the range 1420 to 1970 mm by transposi-
tion of the wheels and mutual positioning of
the wheel disks and rims.
To adjust the track, proceed as follow:
• Brake the tractor with the parking
brake. Put the stops in front and be-
hind the rear wheels;
• Lift the tractor front (or front wheels in
turn) by means of a jack while keeping
the clearance between the wheels and
the ground;
• Remove the front wheels;
• Turn out the nuts fixing the rim to the
disk.
Depending on the required track, set re-
spective rim and disk arrangement as
shown on the diagram.
When doing this, pay attention that wheel
rotation would coincide with the direction
of the arrow on the tyre sidewall.
When transposing the wheels, tighten
the nuts fixing the disks to the flanges
with the torque of 210…260 N m and
those fixing the disks to the rims with the
torque of 180…240 N m.
А, В, С, Д – standard fitting of the disk
with transposing the rim;
А*, В*, С*, Д* – transposing the disk and
rim.
The wheel position with transposing the
disk (letters with asterisks) should be
used in exclusive cases.
To Next Page
Loading...
