Operation of the tractor equipped with a
speed reducer (optional)
1 . Set the change gear lever (4) to neutral
position and reducing gear lever (1) to
foremost or rearmost positions.
2 . Set the speed reducer controls as fol -
lows:
• gear handle (2) to the “ON” position;
• range rod (3) to the “N” position
(neutral).
To start the tractor motion:
1 . Set the minimum idling speed of the
engine.
2 . Step on the clutch pedal.
3 . Set the speed reducer gear handle from
position ON to neutral.
4 . Select the required speed reducer gear.
5 . Set the required speed reducer range.
ATTENTION! It is forbidden to put in the
2
n d
gear of the speed reducer range II at
the 2
n d
gearbox reverse gear.
6 . Put in the required gear of the gearbox
in the range I.
7 . Release smoothly the clutch pedal. If
necessary, increase fuel feed.
8 . Adjust the tractor speed by varying fuel
feed.
Speed reducer gear switching
1 . Set the minimum engine idling speed.
2 . Step on the clutch pedal.
3 . Wait for 3…5 s and then set the change
gear lever to the neutral position.
4 . Put in the required speed reducer
drive.
5 . Put in the 1
s t
gear of the gearbox.
6 . Release smoothly the clutch pedal.
7 . Adjust the speed by the foot-operated
or manual fuel feed control.
Stopping the tractor
1 . Set the minimum engine idling speed
2 . Step on the clutch pedal.
3 . Wait for 3…5 s and then set the change
gear lever to neutral position.
4 . Stop the tractor by applying the service
brakes. Apply the parking brake.
To Next Page
Loading...
