To Next Page

To Previous Page

• Data block MEMORY

The data of up to 20 orders can be stored, i.e. order-specific data such as name, comments as well as

the data recorded during operation such as worked area, operating time etc.

An order which has been stored can be recalled by pressing the T3 key "next memory". The specific

data concerning the order are displayed by pressing the T4 key (next).

The data block MEMORY can only be exited with the T1 "Menu" key.

With the T2 key "delete" the memory can be deleted.

3.3 Operating procedure

The UNI-Control is ready for operation once it has been installed and the machine-specific data have

been entered.

The following operation procedure should now be followed:

- Connect the maschine to the tractor, connect the switch box or machine plug with the UNI-Control,

making sure that it is set in "off" position.

- Switch on the UNI-Control S, the machine adapter identifies the machine automatically and the

corresponding program together with the machine´s specific data are automatically called up.

- Enter the name (plot, customer description)

- Enter or check the pre-set rate

- Enter comments

Name and comments are not compulsory.

The pre-set rate should however always be checked

- Start the order (T2)

- During operation all functions, including those of the calculator pocket, can be selected. The +/- keys

can be used to modify the application rate in degrees of 10% in relation to the pre-set rate.

- The order input is terminated by pressing the T2 key (end). An acknowledgement follows.

- The data which has been recorded - area, working time, applied quantity etc - is now stored.The

order numbers are automatically reset to 0. New numbers are allocated automatically and the

operating procedure can start from the beginning again.

Muller Elektronik UNI-Control S User Manual

Questions and Answers: