To Next Page

To Previous Page

1.3.3 Single seed planter

There are two methods of linking up the UNI-Control S with single seed planters.

• Optical sensor (grain checking)

With the machine adapter "Einzelkorn“ (art. no.: 302 601) the UNI-Control S can be connected to the

optical control devices of the following firms: ACCORD, BECKER; GASPARDO, KLEINE,

KONGSKILDE, NODET and SICAM. In this case the monitoring device of these firms is not required.

The grains per row which are determined are projected to the seed rate/ha and compared to the pre

set rate. If the established rate lies more than 15% below the pre-set rate an optical and acoustic alarm

is set off.

• Reed contact sensor

(Control of the sowing discs when idle)

Behind the mechanical safety mechanism of the sowing disc drive (slip clutch / locking pin) the Reed

contact sensors carry out a control during standstill. In the case of a defect (standstill) an alarm signal

is set off.

Up to 12 aggregates can be monitored using the machine distributor (art. no.: 302 591) 13 and more

aggregates on request.

In addition, both versions can control the following functions:

- monitoring the fan rotation

- monitoring the speed

Variations of more than +/- 15% from the pre-set rate cause an alarm signal to be set off.

Following data is determined:

- Area, total area, distance and working times.

Attention!

When ordering please pay attention to the note "For single seed planters".

1.3.4 Manure cart

The spray rate from a pump and vacuum tank cart is controlled fully automatically. The current spread

rate is measured by a magnetic inductive liquid flow meter.

The spread rate from a pump tank cart is controlled automatically by a bypass valve.

A cross-section control is carried out with the vacuum tank cart.

Muller Elektronik UNI-Control S User Manual

Questions and Answers: