Safety Rules
MANUALS. Always read the appropriate manual or instructions before attempting to operate
or maintain equipment. Make sure that you understand all instructions.
CORRECT SUPERVISION. When in doubt as to the correct way to operate the equipment
always consult your supervisor.
OPERATION OF EQUIPMENT. Do not operate equipment unless maintenance has been
performed on a regular basis, and the equipment is known to work properly. Do not operate the
machine with safety guards removed. The machine must not be left unattended whilst in
operation.
EMERGENCY SWITCHES. Ensure that you know where all emergency switches and stop
buttons are, and you know how to isolate the machine from the main power supply.
WARNING NOTICES. Do not remove any of the warning notices or mandatory signs from the
machine. Ensure that you comply with all such information.
SAFETY DEVICES AND GUARDS. Inspect all safety devices and guards to be certain that they
are in good condition and functioning properly before any operation. The machine is supplied
with guarding required for safe operation. Do not use the machine unless safety guards are in
place.
HAZARDOUS CONDITIONS. Do not operate the machine if unusual or excessive heat, noise,
smoke or vibration occurs. Switch off the machine and report any unusual occurrence.
EARTHING. Ensure that the equipment is properly earthed. The equipment contains digital
signal systems, which are effected by electrical spikes and noise.
ELECTRICAL ISOLATION. Before any repair or maintenance work is undertaken on the
machine ensure that the main electrical power is fully isolated.
MAINTENANCE WORK. Do not reach into any control or power box unless the electrical power
is turned off, do not touch any electrical equipment if hands are wet or when standing on a wet
surface.
AUTHORISED PERSONNEL. Do not allow unauthorized personnel to have access to electrical
enclosures containing electrical equipment. Do not allow untrained personnel to operate or
repair the equipment.
REPLACEMENT EQUIPMENT. Always replace blown fuses with fuses of the same rating, size
and type as the original.
WARNING
Machine must only be operated by persons trained
and accredited by Multicam Systems
To Next Page
Loading...