Corrosion
Some of the components of the machine may be subject to corrosion in unfavourable conditions.
The machine should be used in a dry, moisture free atmosphere and should not be exposed to
water-based fluids or lubricants. The machine should not be exposed to acidic or alkaline
substances and it should be maintained in accordance with the servicing schedule.
General Safety Rules
It is essential that these instructions are made available to the machine operators. It is also
important to hand them on if the machine is sold or given to another user.
The machine should only be used by a suitably trained operator. Other personnel within the
organisation should be aware of the methods to stop the machine in an emergency.
The machine is intended for use solely as a 3-axis router and cutter of materials. It should never
be hammered on, nor used as a general workbench, or for any other purpose than that for which
it was designed. This is likely to damage the machine and may compromise operator safety. It
may also void the manufacturers warranty.
The machine must not be operated after the consumption of alcohol or the taking of any
medication or drugs which may cause drowsiness or loss of attention.
Machine must only be operated with all safety guarding in place. The machine cutting heads
including spindles and oscillating knife heads are supplied with safety guarding. Do not operate
the machine with safety guards removed. Do not activate clamping systems unless it is safe to
do so. Ensure all clamping devices are clear of obstruction and that machine operators or other
personnel cannot be injured prior to activating the device.
All emergency stop devices must be in full working order before operating machine.
We STRONGLY RECOMMEND that safety mats, laser safety curtains or other safety
barrier devices be fitted to machines with a process area exceeding 3600mm in length
or are fitted with aggregate head attachments or any other attachment that can pose a
safety risk. Safety interlock outputs are available on the controller for the connection of
these devices.
Machine must not be operated with danger or non-operation tags in place.
The machine must not be left unattended whilst in operation.
WARNING
Machine must only be operated by
persons trained and accredited by
Multicam Systems
To Next Page
Loading...