Materials Suitable for Cutting
The machine is designed to cut, engrave and form a wide range of materials, as detailed below:
• Plastics - all plastics can be cut, including the 'hard' plastics such as polycarbonate.
• Woods - the majority of wood-based materials can be readily cut, including MDF,
plywood and other composite boards.
Note. When cutting some types of hard wood, e.g. mahogany, jarrah etc an appropriate
form of jigging will need to be considered.
• Metals - aluminium, brass and other soft metals can be readily cut. The hard metals
such as stainless steel can be cut, but due care must be taken regarding the depth of
cut, feed rate and cutter used. If in doubt, consult an appropriate person or the
manufacturers agent or machine supplier.
Other hard materials, such as carbides, should not be cut on the machine due to the risk
of damaging the machine or endangering the operator.
Note. When cutting metals a suitable lubricant should be used. Flammable fluids such
as Methylated spirit must not be used.
• Foams - all foam-based materials, such as sign foam, can be readily cut.
• Cardboard, rubber and insulation materials - most of these products can be cut using
an oscillating knife head
• Composites and Laminates - some composites and laminates, such as fibreglass, can
be cut. Please contact the manufacturers agent or machine supplier for more
information.
Dust Extraction
Dust may be produced during machining operations and this may introduce a risk of fire or
exposure of the operator to a hazardous substance. A suitable form of local exhaust ventilation
(LEV) must be fitted to the machine to remove machining dust. Outlets for extraction hoses are
fitted to the dust pickup head supplied with the machine. The hose must be firmly secured to the
fitting.
Note. Always ensure that the extraction system is clear of obstructions and is in correct working
order before using the machine. On dust extraction systems with manual cleaning devices follow
the manufacturers recommendation for regular cleaning. Filters should be cleaned daily.
Mist Dispensing Systems
Mist dispensing systems, such as Trico and UNIST cooling/lubrication systems, are designed
to assist in the cutting of ferrous and non-ferrous materials by delivering a fine mist of fluid under
controlled pressure. Only use recommended fluids in these devices. Flammable fluids such as
Methylated spirit must not be used and will cause damage to the devices. The use of non-
recommended fluids in mist sprayers will void manufacturers warranty.
To Next Page
Loading...