Personal Protective Equipment
It is recommended that the operator, and other persons working in the vicinity of the machine,
use the following personal protective equipment in conjunction with the machine:
• Hearing protection
• Eye protection
• Gloves when handling materials to be machined
• Cut proof gloves when changing router bits, knife blades or other cutting tools.
Note: The supply and wearing of personal protective equipment is regulated by Workcover.
Training and Support Services Offered
In addition to the training provided during initial installation of your machine, Multicam offers a
range of extra training services as refresher courses or for the purpose of training additional or
new operators. These services may incur additional charges, of which you will be advised at the
time of application.
Onsite
We can provide onsite training to ensure a high level of machine operation competency
for your staff. Onsite training is beneficial in that it utilises your equipment and can be
tailored around your systems and procedures.
At Multicam Premises
Training at one of our offices can be provided for your staff. This is usually more general
training and is beneficial in that there are minimal disruptions. This type of training is well
suited to in-depth software training.
Remote Access
With Remote Access we log on to your computer via an internet client service. This can
enable us to assist you in diagnosing various operational or software issues. The service
can be affected by your internet connection or availability. Remote access is not suitable
for training new staff or staff with no prior experience, rather it is best suited to assist
previously trained staff or operators in areas that they may be unfamiliar with.
Remote access may also be employed by technicians to view your machine
configuration or settings.
To access additional training, please contact your nearest Multicam office.
To Next Page
Loading...