7. Communication with PC
The oscilloscope supports communications with a PC through USB. You can
use the Oscilloscope communication software to store, analyze, display the
data and remote control.
To learn about how to operate the software, you can push F1 in the software
to open the help document.
Here is how to connect with PC. Please download the oscilloscope
communication software on our official download website and install it to your
computer.
(1) Connection: Use a USB data cable to connect the USB Device port in
the right panel of the Oscilloscope to the USB port of a PC.
(2) Install the driver: Run the Oscilloscope communication software on PC,
push F1 to open the help document. Follow the steps of title "I. Device
connection" in the document to install the driver.
(3) Port setting of the software: Run the Oscilloscope software; click
"Communications" on the menu bar, choose "Ports-Settings", in the
setting dialog, choose "Connect using" as "USB". After connect
successfully, the connection information in the bottom right corner of the
software will turn green.
Figure 6-1 Connect with PC through USB port
To Next Page
Loading...
Need help?
General
