Multiplex ALBI 4 Series User Manual

15
Section 3
2. Putting the unit into programming mode
Plug the unit into the mains power supply
and the initialising screen below will be displayed.
Within four seconds of powering up the unit, press
andholdbuttons1&4andtherstsettingscreen
will be displayed which is detailed in section 4.
3. Enabling\Disabling the fridge system,
carbonator pump and dispense valve
The function of this screen allows the user to
Enable\Disable the fridge system, the carbonator
pump and the dispense valve if required.
Pressing button 3 (+) will move to the next setting
screen and pressing button 2 (-) will move you back
to the previous screen.
Pressing button 4 will take you into the sub
menu to change the settings as below
The top row shows the status of the three options.
X = Disabled Tick = Enabled
Toggle buttons to enable / disable components
Button 2 = fridge
Button 3 = carbonator pump
Button 4 = dispense valve
Pressing button 1 will return you back to the
previous screen. And then press button 3 to take
you to the next setting menu.
Note: when in dispense mode, if the dispense is
disabled, this message will be displayed. If the
fridge and/or the carbonator pump are disabled,
no message is displayed.

Multiplex ALBI 4 Series Specifications

General

Brand	Multiplex
Model	ALBI 4 Series
Category	Dispenser
Language	English