33
10. Flight phases
The WINGSTABI has 4 individually usable ight phases.
Flight phase off (Flight phase 1)
The WINGSTABI is switched off and forwards control commands directly from
the transmitter to the servos.
Damping mode (ight phase 2)
For normal ying. External inuences such as crosswinds and landing are mini-
mized. Here we are referring to a type of “wind canceling” functionality.
Full Heading Hold (Flight phase 3)
For elaborate acrobatics. This mode can only be used to a limited extent during
landing and take-off, as it demands a certain level of experience in ying the
WINGSTABI. Stalls are often detected too late by the pilot here. The advantage
is that the model remains absolutely consistent even with heavy winds. What
makes the WINGSTABI special here is that control over the rudder is specially
optimised, thus ensuring a realistic airborne appearance.
Torque-rolls! (ight phase 4)
Extreme heading hold mode. This mode is unsuitable for normal ying. The
model would soar upwards.
How do you activate the fourth ight phase, which cannot be activated in
the standard conguration?
In the software, switch to the receiver settings window “assign fourth ight
phase”. An additional channel with 2-stage switch must be assigned.
This switch is overriding and switches off your WINGSTABI when pressed
in ight phase 1. The previously assigned 3-stage switch for the ight
phases now switches between phases 2, 3 and 4.
i
To Next Page
Loading...
Need help?
General
